I have installed the firmware and accessed the setup screen. Upon hitting "save" the screen displayed it would take 60 seconds to reboot. It provided the network address to enter:

localnode.local.mesh:8080

or

wd4hxg-Sterling.local.mesh:8080

to log back in. I tried both but the timeout message was displayed. Running IPCONFIG revealed a 169.x.x.x  address on the RJ-45 port on the computer. See the below take on the Command Line Display where the ipaddress is displayed.

I am currently lost. I have powered down the Bullet and brought it back up. Even after powering back up the default NOCALL-6-173-4 is displayed in the wireless connections window. If I disconnect the RJ-45 Ethernet connection the IP address for the wired lan is not displayed using ipconfig. Reconnecting the RJ-45 the 169.x.x.x address returns.

Any suggestions on accessing the device.

Thanks

Chuck