Broadband-Hamnet™ Forum :: General
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Wireless Access Point.. 2014-04-25- 03:43:58 
VE7SML
Member
Joined: 2014-04-25- 00:40:10
Posts: 2
Location: 

I have two WRT54G routers that were set up as mesh nodes, VE7SML-1 and VE7SML-2. I am new to this stuff and set VE7SML-1 to a Wireless access point. Now I can' t connect to it. I read the FAQ's and found the advice to connect the two routers with a LAN cable and then connect one to the ethernet port of my computer, which I did. I then tried to point my browser to 172.27.0.2:8080 and still no luck.

My computer says that there is wireless signal from both VE7SMl-1 and VE7SML-2. 

I want to change the WAP back to a mesh node.

Thanks

Mike VE7SML
IP Logged
 Subject :Re:Wireless Access Point.. 2014-04-26- 06:45:02 
VE7SML
Member
Joined: 2014-04-25- 00:40:10
Posts: 2
Location: 

I found out another problem, I changed the SSID to VE7SML-1 too. Can't get back into setup to change it back to BroadbandHamnet-v1. Any help would be much appreciated.

Mike VE7SML
IP Logged
 Subject :Re:Wireless Access Point.. 2014-04-26- 10:48:14 
KF5JIM
Future Astronaut
Joined: 2013-07-17- 12:13:36
Posts: 250
Location: Nederland

Probably the fastest method would be to tftp the firmware back to the router:
http://www.dd-wrt.com/wiki/index.php/Tftp_flash
IP Logged
My opinions and views expressed here are solely my own.
Page # 


Powered by ccBoard


SPONSORED AD: