I've seen everything from Omin's to high gain directionals used. I'm looking at SECTOR's for a tower site (The NanoStations are basically all in one sector setups as well) The AirGrid has a high gain unit built in, as to the NanoBeam/NanoBridge (dish based) For demonstrations ive been using just small panel antennas (similar to NanoStation) and small low gain omni's (on a bullet) and for long range I did some testing with a grid (single polarity) that was originally hooked up to a Linksys before being swapped out.
A note about the 2 antenna ports, when running in a diversity mode they are intended to receive different paths between two similar type antennas (aka 2 omni, or 2 different polarities on a dish, etc) from the same sending station.
This 'multi antenna' ability has been (ab)used on the Linksys to use an omni and a directional dish, it works, but it wasn't how the devices were meant to operate.(Someone posted a much better explanation some time back in the forum) So while it works keep in mind the unit will take the strongest signal it gets on either antenna. This means one port could 100% mask another port (this could be what you want in some cases) while a remote party is transmitting.
Ive already seen setups of Ubiquiti do the same, and again it works, just be aware of the limitation that if two people are shouting at you than you can only hear the loudest person. If you try and ramp up to the much higher speeds (150mps) than you actually need both ports pointed to the same direction as it relies on the multi-path multi-polarity to ramp up to higher speeds (802.11n)
|