I just "found" a Smart Power Switch from webpowerswitch.com... it has a LAN interface which allows it to be controlled over a LAN on port 80 through your browser...

It's default address is 192.168.0.100 subnet 255.255.255.0 ....

I can't seem to get it onto the subnet of the mesh network to be able to use it to control remote devices plugged into it... anyone have experience in reassigning it's address and subnet settings to be able to come up on the mesh??/ it can not be configured for DHCP and can be set to allow access from other subnets, but when I try to give it a 10.xx.xx.xx address on the 255.255.255.248 subnet, it gives me an error message saying invalisd network settings...

Could it be that because I am accessing it over a 192.168.XX.XX network, it disagrees with the changes... I would assume it would accept them and then become unavailable on the 192.XX.XX.XX network and become available on the 10.XX.XX.XX network...

Am I missing something here???? it's been a LOOOONG day at work and I wanted to get this up and running tonight...

Rich

N2PPN