Broadband-Hamnet™ Forum :: Firmware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Can I load the bin File into an empty memory?.. 2013-12-01- 09:23:32 
WB6IWT
Member
Joined: 2013-11-10- 10:34:57
Posts: 8
Location: 

Hi,

    i just unbricked my WRT54GS V3 by reloading the CFE, got it pinging and before I install the Hamnet software was wondering if I should proceed with loading the bin software. The instructions assume you have the original linksys software in the router OR you are updating the Hamnet software that is already installed. I would reaslly appeciate a little advice from those in the know.....

Thanks

Paul

WB6IWT
IP Logged
 Subject :Re:Can I load the bin File into an empty memory?.. 2013-12-01- 09:50:46 
KF5JIM
Future Astronaut
Joined: 2013-07-17- 12:13:36
Posts: 250
Location: Nederland

Before proceeding, I would erase the nvram and kernel. From there I would reload the .bin file via tftp (either stock linksys and then upgrade or the openwrt image) as jtaging it woudl take too long.  You could proceed either way as the wrt54g* will load either one without the other first.

That's my process when I unbrick devices using jtag.

Paul
KF5JIM
IP Logged
Last Edited On: 2013-12-01- 09:53:26 By KF5JIM for the Reason
My opinions and views expressed here are solely my own.
Page # 


Powered by ccBoard


SPONSORED AD: