So I was working on upgrading a few of my routers to HSMM when I noticed that there was a firmware file for the WRT150N. Being in ownership of one of these units I decided to upload the firmware. So it upgraded Fine but now when I try to do the initial Setup where you put your call sign in it gives me an error saying invalid IP address.. the IP address is 10.0.0.0 which I am sure is wrong as it looks differently than my other 3 routers. Now i know that this unit works on the 5ghz band rather than the 2.4 so it wasn't going to work with my existing hardware but can someone with experience help me out? Thanks !

KF7EUP

Some wireless N (802.11n) devices may work on both 2.4 GHz and 5.8 GHz.

I think the WRT150N is actually 2.4 GHz only in the factory configuration, and doesn't have 5.8 GHz hardware.

In any case, I would expect it to do 2.4 GHz only once BBHN is loaded on it.

What version of the firmware is loaded on your other routers? Are you using the Broadband Hamnet firmware on all of them, or are some of them still using HSMM firmware?  What IP address do you get for the other routers.

Was the IP actually 10.0.0.0, i.e. the last 3 octets were 0?  That's certainly not valid in any case.  10.x.x.x is valid, but they can't all be 0.  

We don't have many people who have loaded the WRT150N.  Can anyone who's successfully loaded it post here to confirm it works?

I have a WRT150N and have tried to flash it with no luck.  The issue is that it times out after 8 seconds after starting the flash.   I am using the bbhn-1.0.0-wrt150n.bin  Looking for any ideas/suggestions. Thanks-