I wish to thank everyone that helped on my last problem well here's the next problem one one mesh router is the asterisk server when I connect the spa1001 adapter every thing works great and I have the other spa 1001 connected to a different mesh router it registers to the server but when I dial the extension I get an error 503 service is not enabled the ports have been opened on that router and the one with the server on it but the the problem is is the problem with asterisk or the router settings the settings for the spa1001 are the same for both adapters and the IP address have benn configured with the proper settings to point to the server they all register but when I dial the ext on the router with just the adapter it says error I,m thinking its an router issue I,m running the new update on all the routers do I need to make them a nat for this to work or is the setup different for the new update 1.0 

Each SPA1001 must be registered to a different extension number. Keep the nodes in "5 Host Direct" and you will not need to forward any ports. By keeping it in "5 Host Direct" we can rule out it being a router issue.

thank you that was the problem i though you had to do port forwarding with the new firmware it works great now thank you and this group helps the new people out very well