Broadband-Hamnet™ Forum :: UBNT Firmware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Bullet M2 doesn't save changes.. 2014-05-20- 08:18:28 
KJ4CTD
Member
Joined: 2014-05-13- 19:49:09
Posts: 2
Location: 

Ok, so the first bullet I did, everything went fine. The second bullet loaded up the firmware fine, but will not save the ssid or password when I tell it to. It also stays on the 192.168.1.1. Any ideas?

I also noticed that the top led (on the signal strength) is on.

EDIT: Nevermind, it was a case of the browser being stupid.
IP Logged
Last Edited On: 2014-05-20- 08:29:40 By KJ4CTD for the Reason
 Subject :Re:Bullet M2 doesn't save changes.. 2014-05-20- 08:30:20 
KG6JEI
Member
Joined: 2013-12-02- 19:52:05
Posts: 516
Location: 

 I would suggest closing your browser and re opening as a start to make sure nothing is cached in it's memory. If that doesn't work try a full cache clean on your browser.

Top Link LED should be on solid -  this signifies the router has completed booting.
IP Logged
Note: Most posts submitted from iPhone
Page # 


Powered by ccBoard


SPONSORED AD: