Broadband-Hamnet™ Forum :: Firmware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :How to monitor the WRT54G boot process & install drivers?.. 2013-12-04- 09:05:25 
N6SXR
Member
Joined: 2012-07-30- 08:05:31
Posts: 35
Location: Stormy Acres

I am adding the USB option to a WRT54G V2 as outlined by K5KTF.  When it gets to the part on installing the drivers/sw for the USB ports I notice he is displaying the boot process, etc.  How is this being done on the router?  Is there a specific port or something to connect to to monitor what is essentially the console.

Kirk - N6SXR
IP Logged
 Subject :Re:How to monitor the WRT54G boot process & install drivers?.. 2013-12-05- 06:46:35 
kv4pc
Member
Joined: 2013-09-30- 20:06:03
Posts: 47
Location: Madison, AL
 

The command dmesg will show you the kernel messages generated during the last boot cycle.

A good write up with reasonable examples is here:

http://www.linfo.org/dmesg.html

This might also prove to be useful:

http://wiki.openwrt.org/doc/howto/log.essentials

73;

Bob KV4PC
IP Logged
Last Edited On: 2013-12-05- 06:47:20 By kv4pc for the Reason
Page # 


Powered by ccBoard


SPONSORED AD: