Broadband-Hamnet™ Forum :: Hardware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :can't access the router after flash.. 2013-07-30- 05:14:13 
kb7pln
Member
Joined: 2013-07-29- 11:11:29
Posts: 2
Location: idaho
 

after many tries to flash the firmware it took but now i can't access the router to set it up any help ???
IP Logged
 Subject :Re:can't access the router after flash.. 2013-07-30- 09:59:41 
wx5u
Member
Joined: 2013-01-02- 00:30:45
Posts: 188
Location: Austin, TX

How are you trying to access the router?

What kind of PC? Windows, Linux, etc.?

Have you rebooted the PC to be sure you get a new IP address?

IP Logged
I'm not part of the development team, so take what I say with a grain of salt. I'm also easily confused.

Check out the free Wireless Networking Book
 Subject :Re:can't access the router after flash.. 2013-08-02- 09:47:08 
kb7pln
Member
Joined: 2013-07-29- 11:11:29
Posts: 2
Location: idaho
 
well i figured out after e-mailed Jim he helped me figure it out now i'm trying to figure out if it uses both antennas or not i'm not a newbie to networking but i'm still a novice . this is very different to what i'm uses to now i have to figure out how to use the other software always on the learning curve that's me lol
IP Logged
 Subject :Re:can't access the router after flash.. 2013-08-02- 15:41:50 
wx5u
Member
Joined: 2013-01-02- 00:30:45
Posts: 188
Location: Austin, TX

By default, it will use both antennas.  You can change this on one of the panels on the web interface.

IP Logged
I'm not part of the development team, so take what I say with a grain of salt. I'm also easily confused.

Check out the free Wireless Networking Book
Page # 


Powered by ccBoard


SPONSORED AD: