Hi, just updated my M2 to v3.0, that went ok, however I am not seeing any received s/n ratio or other modem on my local mesh. If I do a wi-fi scan I see about 25 locations so it is receiving ok but does not appear to be transmitting, any ideas?

Version 3.0.0 beta will be running  protocol version 3 and is not compatible with previous versions.

Make sure to flash at least one other device 

Thanks Conrad

Can't flash the others in my set up as they are Linksys WRT54G3g ones, can I revert the 3.0  to the earlier non beta version

Andy

I see a wrt54g3g image under the Linksys downloads as well.

Yes you can load an older firmware if you want I to the node

Ok, will give it a go, tnx..

Downloaded Linksys 54g3g beta 3.0 trx file and it is working a treat!, can see all my 2 Linksys and M2 modems in my local mesh node!

Thanks Conrad..

Just one further question, am I right in assuming that the LED signal strength indication is not fully functional. In my local mesh the first LED is glowing red and the last one (green) is illuminated.

We do not utilize the LED's during normal operation for signal strength indication we currently normally use them for status information to provide easy user feedback as to the node operational status.

Top solid green (Link4) generally mean the node has finished starting, flashing is early in the boot process has begun but not yet successfully finished.

Red (Link1) means we have a connection established with a neighbor (nodes should begin showing up in the status list)

Remaining 2 are reserved for future use.